What does that sound like? My new CNC router is limited to about 31″ x 32″ Originally Posted by LTD Next thought was to look at a passive radiator. Runs out of excursion between 20 and 30 Hz depending on added mass. Not much extra work to have the option of testing both configurations. Need a little help
|Date Added:||20 May 2018|
|File Size:||28.98 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Originally Posted by LTD Remove Advertisements Sponsored Links. What does that sound like? I’m calculating roughly 8.
ok who have any info on jbl h
Probably little to no difference for a low tuned build. I used the 3″ Precision Ports on the M2 clone so I figured a pair of the 4″ or 6″ should do the trick.
I picked up a H to build a Sub18 clone go with my M2 clones or close enoughs. Any help or advice on optimization would be appreciated.
Come to think of it I could incorporate the slot port into a riser to get it up off the floor and eliminate 226h “problem” of the port consuming box volume assuming I give up on round ports. BB code is On. I also have some rosewood veneer I plan to use and need to verify the dimensions before I get too far into it.
Used jbl h for Sale |
I suspect I won’t be running near peak power except to show off the system occasionally. I guess my question really come down to finding the solution that is most tolerant of being driven stupid loud at 20Hz while yielding acceptable SQ.
Need a little help You guys are a great resource. The Sub18 specs http: For the best viewing experience please update your browser to Google Chrome. I’m not sure if a single p. I’m not sure if the ports are straight ports or not.
Keeping within the spirit of the SUB18, but going bigger cab, bigger ports, lower tuning Last edited by LTD02; at No doubt bigger is better but this is going in the living room so sticking closer to the original size is a good idea.
JBL 2269h 18″ Speaker 354096-001x 8 Ohm
JBL H – ported or passive? Anyone know where to find a 5″ diameter flared port? My new CNC router is limited to about 31″ x 32″ Let’s assume watts peak Crown XTi bridged mono Guessing from the photo ports are Originally Posted by mobeer4don.
I’ve been kind of curious too, so I grabbed the front perspective image from the site. Runs out of excursion between 20 and 30 Hz depending on added mass. Next thought was to look at a passive radiator. Not much extra work to have the option of testing both configurations. Wow Don-where were you able to find the ?
Haven’t done the math on slot ports because the first goal was to match the Sub18 look if you can call it that. Originally Posted by Wrager. Unfortunately the port velocity is very high for the 4″ ports below 40Hz. AVS Forum articles Contests.