When installing a CPU heatsink and cooling fan make sure that you DO NOT scratch the motherboard or any of the surfacemount resistors with the clip of the cooling fan. Application Tab Lists the software utilities that are available on the CD. Installing the Motherboard 8 Do not over-tighten the screws as this can stress the motherboard. Pin 1 is labeled. Install the edge connector of the add-on card into the expansion slot. IDE Speaker header 6. Connecting Case Components Connecting Case Components After you have installed the motherboard into a case, you can begin connecting the motherboard components.
|Date Added:||6 August 2011|
|File Size:||35.73 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Audible Download Audio Books. Look for the chipset and motherboard model; then browse to the directory and path to begin installing the drivers.
ECS > G31T-M9 (V)
Push the latches on each side of the DIMM slot down. Use the cursor arrow keys to move the highlight to other options. The clock speed and system bus are determined by the kind of processor you have in- stalled in your system.
An item installation screen appears: When setting the jumpers, ensure that the jumper caps are placed on the correct ece. It eliminates limitations of the current Parallel ATA interface.
They are provided mainbiard for the convenience of the customer. Integrated Peripherals Integrated Peripherals This page sets up some parameters for peripheral devices connected to the system.
First I purchased this board several years ago, and was under impression that it’s an entry board. The total memory capacity is 4 GB.
ECS G31T-M9 Manual
When mainhoard Save and Exit dialog box appears, select [OK] to save and exit, or select mainbowrd to return to the main menu. Over-clocking can permanently damage the motherboard by generating excess heat in components that are run beyond the rated limits.
This concludes Chapter 4. When installing a CPU heatsink and cooling fan make sure that you DO NOT scratch the motherboard or any of the surfacemount resistors with the clip of the cooling fan.
ECS G31T-M9 – – motherboard – micro ATX – LGA Socket – G31 Overview – CNET
These limits are designed to provide reasonable protection against harmful interference in a residential installation. Increase the separation between the equipment and the receiver. The time requirement is due to internal de-bounce circuitry.
Neither this manual, nor any of the material contained herein, may be reproduced without written consent of the author.
Image Unavailable Image not available for Colour: Always remove the AC power by unplugging the power cord from the power outlet before installing or removing the motherboard or other hardware components. Follow these instructions to install an add-on card: This file contains the information needed to locate the drivers for your motherboard.
Page 25 Refer to the illustration below for proper installation: If you have this kind of case, use auxiliary USB connector to connect the front-mounted ports to the motherboard. Do not over-tighten the screws as this can stress the motherboard.
ECS G31T-M9 – 1.0 – motherboard – micro ATX – LGA775 Socket – G31
Operation is subject to the following conditions: Setting Jumpers G1t the motherboard jumpers to set system configuration options. Remove a blanking plate from the system case corresponding to the slot you are going to use. Refer to the table below for information: Attach the other cable end to the SATA hard drive. First, some features on the motherboard are implemented by cabling connectors on the motherboard to indicators mainboars switches on the system case.
Please noted that the frequency will be varied with different CPU. Describes features of the motherboard. Avoid using cooling fans with sharp edges on the fan casing and the clips.